Add door stops to the inside of the jamb to keep the door from swinging through it.
Installing interior door and frame.
Schedule an in home measure and ask your authorized measure technician to look at the backset size so that you can be sure to choose the right deadbolt lock the most.
Tape your level to a straight 2x4 as shown.
Check the whole length with your straightedge.
Next shim the center area of the jamb to straighten it and then nail it.
Place a bracket behind each of the three hinges.
Drive two nails through the frame through the shims and into the studs.
After the frame is set i usually like to hang the door to check the fit and twea.
A prehung door is a unit that comes with hardware and a frame ready to be installed into a doorway.
Attach the door installation brackets.
Also measure the jamb depth.
Next consider the door frame.
If your frame is in good shape a slab also called a blank door image to the right is fine.
Remove the interior trim and measure the width and height of the frame.
Shim the bottom of the door frame about 4 in.
Purchasing one does simplify and speed up installation but the term prehung is really a misnomer.
Attach the remaining three brackets on the the other side of the jamb.
It s a good idea to measure the actual door too.
Level it out against the door frame by placing shims behind it.
Most security doors come in a prehung frame.
Look for doors with a metal screen of thick gauge steel which allow for a full view and ventilation.
If you re installing a pre hung door make sure you get the correct.
Installing the door frame that i made from the parts in the previous video.
Attach 6 door installation brackets to the outside of the door jamb the wood frame to which the door comes pre attached.
The new door should be 1 2 inch less than the height of the rough opening and 3 4 inch less in width.
These doors and jambs must still be carefully adjusted to account for shortcomings in the wall frame.
To install the jamb the right way nail measured pieces of wood together to form the jamb s frame.
Drive two nails through each shim about an inch from each edge of the jamb with one about a inch above the other.
Whichever type you use there are a variety of styles available to match your home decor.