Mount a low voltage plate to the wall and then fish the fire up to it finish it with a wall plate.
Inexpensive way to run ethernet to basement from second floor.
Punch a hole from the basement assuming you have one into the wall where the router is.
Might take some work to get up there.
Getting through the wood at the base of the second floor isn t as hard as getting through the fire blocking horizontal 2x4s in the stud cavity.
Best way to run cable from basement to second floor need to run some cables coax power cat6 from the basement to the second floor attic bungalow in 3 different places.
The two wiring standards for ethernet cable termination are t568a and t568b.
The bigger the hole the better.
But can be done.
Use the coat hanger to see if everything is fine at this location and there are no obstructions.
What i personally have done is just run the wire myself but it s a lot of work.
Then drill up from the basement into that same wall cavity and use fish tape to get all the way up.
Running through interior closet walls for all three.
When running ethernet cable its always best practice to run more cable length than is needed in case something is done wrong on the termination side.
Find a good place to run the wire from the basement to the attic.
Other places i had to drill.
Sometimes i was able to use existing holes from phone wiring.
Purchase here best price.
Learning how to run the cable from basement to the second floor once you are all set simply shut the power off from the main board and get started.
The ethernet cable will pass through the top floor into the basement at the closest point to the location of the device on the lower level.
Wherever you want to put the outlet drill a small hole.
The really really cheapest way is to run your ethernet cable along the floor and through the doorways.
One will run next to a heat duct that goes up to the second floor.
On an interior wall you can cut the opening for the wall plate on the 2nd floor then use a flex bit to drill down into the cavity of the wall on the first floor.
The second cheapest way is to drill a hole in the floor of each room near a convenient wall and pull a cable through basement or crawl space.